Case for Lee Reloading Dies with Hornady Bushings

thingiverse

NOTE: This is a living breathing design, I will be constantly tweaking it so ideally check to see if there is a new stl if you find issues. If using the Hornady Lock n Load System with Lee dies, the original Lee case will not close completely due to the increased diameter of the dies with the Hornady Bushings attached interfering with the top. This is a semi-faithful recreation of the case that will allow the top to go on properly as well as continue to be stackable. The biggest changes were: - adding embedded text in each die spot for the stls available - adding text at the end for the calibres - changing the receptacle that the powder scoop sits in so it will fit a spare shellholder if need be. The STLs cover the following calibers: 9mm 45 ACP 30-06 (4 die) 7.62x54 Russian (3 die) I have also included a bare model with no text. As an alternative, I also created a spacer you can insert on top of the normal containers which reduces the amount of time printing compared to the full case. Pictures based on prototype which is missing the small walls that keep the powder scoop in place