Case for the side slot MSX cartridge adapter

thingiverse

This is the case for the RBSC's side slot cartridge adapter module. The Yamaha's network module's case was used as the source of this design. The adapter module can be inserted into the side slot of Yamaha MSX computers: YIS805, YIS503 and similar. The case and the bottom cover as well as the pin, slot cover and its handle must be printed separately. The case and covers must be printed with Brim and with their open side facing upwards. The pin and the cover handle must be printed vertically. The side cover is necessary to protect the cartridge slot when there's no cartridge inserted. The cover must not be glued to the case - you should be able to easily remove or install it when necessary. The "noholes" version of the cover is also provided for the printers that can't print the initial layer properly if there are small holes there. The hole must be cut in the cover's body with a sharp knife. Four 3mm x 20mm screws should be used to attach the bottom cover to the case. The module itself should be secured in the MSX computer's side slot with the original 3mm x 33mm flat head screw. The adapter's project can be found here: https://github.com/RBSC/SideSlotCartridgeAdapter If you want to make a small donation in appreciation of my humble efforts, please use the "Tip designer" button on this page: https://www.thingiverse.com/Wierzbowsky/designs