Cat Door

thingiverse

A cat door that I made over a year now and finally decided to upload. I use magnets to keep the door from blowing open in the wind(magnets on door and frame), i believe the magnet hole is 20mm but ive just been using some 10mm ones i had around.... one on each side of plastic keeps them from falling off If i remember correctly you want frame and door opposite polarities for them to lock together I also had to use a small drill bit and pliers to make the hole a bit bigger for the 6-32 screw i used for the pivot point..... this may not be neccesary depending on how the print goes The frame is 10" diameter so its a relatively big print, although you might be able to get away with scaling it for smaller printbeds/cats