Cat Fountain

thingiverse

Cat fountain inspired by [Marcus Lanzoni](https://www.thingiverse.com/thing:2583567). It has a bigger reservoir, the minimum water level is lower and the motor is protected against water level rising too high. You can print it without supports, it needs a brim and a maximum infill density to minimize water permeability. I used the same DC motor as in this [water pump](https://www.thingiverse.com/thing:2111988). I took a 18V power supply from an old laptop and it works fine. You can use any power supply with voltage upper than 5V. Print it with PETG or ABS, PLA is not water resistant. I used PETG because it is more adapted to food contact.