Cat Noir ring (Default size 8)

thingiverse

EDIT: THE SIZE OF THE RING IS WAAAY TOO LARGE! SCALE IT DOWN TO AROUND 25 mm (MILIMETERS) FOR A SIZE 8 RING! ALSO, THIS WILL PROBABLY BE REPLACED SOON BY A BETTER FILE! LASTLY, WHEN PRINTING, EDIT THE FILE SO THE PAW ON THE RING IS FACING UP SO IT PRINTS THE PAW LAST SO YOU WON'T HAVE TO DIG OUT THE SUPPORT MATERIAL, THIS MAKES FOR A CLEANER PAW!!! I grabbed the model from someone else where it was two separate filed, the paw was bigger than the ring so I made a few changes here and there, made it a single file, a resized the paw so it should fit perfectly in the hole. Now i'm not an expert at sizing but i'm 80% confidant that this should fit a size 8 finger. However, obviously you could scale the file up or down to fit whatever size ring you need. To do so here are some references: https://www.greenlakejewelry.com/ring_size.aspx then take the 2.23 (this is in inches), change it to your ring size, then use http://percentcalculators.com/percent-change-calculator-finding-percent-increases-or-decreases/ "From 2.23" "to (your ring size)" take the percentage and in google you can type 1.7+/-(percentage) 2.48+/-(percentage) and whatever the total is, scale the ring respectively. do the same thing for the paw.