Cat S60 Microphone/loudspeaker mesh

thingiverse

Tried printing out another such mesh, but it would not jive with my setup(PLA on Creality 3), so I made a new one instead. Then I discovered that there were more versions from more makers... There is both orientations so it's easy to choose if you want the up or downside from the printplate to be upside on the phone. There is also both 0.5mm and 1 mm versions. The 0.5 mm should fit right in, while the 1mm would be best if you want to sand it down for moar smoothness. Should be easy enough to install with double-sided tape or glue(be careful about to not get glue down the ports). According to what I've read, the mesh should be of no importance vs the phone beeing water-tight. I am new at this, third design and first upload, but think it turned out fairly well.