Centrifuge - Quick Print One Piece Gravity Hold System

thingiverse

USE AT YOUR OWN RISK! Samples may come loose or break at extreme speeds! The two slot widths are 11mm and 13mm. If you want a custom slot diameter, leave it in the comments and I can modify the existing file and upload it. This is a remixed version of the DremelFuge. The differences are in the hold down method and attachment type. This requires a bolt, and works best with a carriage bolt, as the center hole is square. The depth is about 3/4", so a 1" or longer bolt and nut is required. Washers are recommended. There are two models, CW and CCW rotation. Make sure to print the one you will need so the samples are forced down into the slot rather than fly out. The CW and CCW are labeled as if you would be driving it from the bottom (an upside down dremel or drill for instance). There is nothing to say you can't mount it from the top on a bench press or the like. The slot angle is 20 degrees, so it does not need support. Average print time on a Delta Printer at 200 micron height with infill of 20% is just shy of 2 hours, so it is a quick print. Print Settings Printer Brand: SeeMeCNC Printer: Rostock MAX v2 Rafts: Doesn't Matter Supports: No Resolution: 200 micron Infill: 10 - 50% Notes: Infill can be whatever you want. 20% is good and strong, more infill will increase strength.