cereal box house

thingiverse

this is a remix of Cereal Box Townhouse by dadhoc, I have changed the design a little bit. Made a double door entry, so that bigger toys could fit inside, also there are two different windows. wanted to create one window that is not flat, but sticks out a little bit, more 3d than the other one. so this special window will need support when printed, didn't have any problems with that. all parts fit well for any kind of cereal box. My 3-year-old daughter likes it a lot and I hope you will like it too! Print Settings Printer: Flashforge Finder Rafts: Doesn't Matter Supports: Yes Resolution: 0.12mm Infill: 5 - 10 % Notes: I have used PLA for my prints, and it doesn't stick well, so I decided to use rafts, I think it's not necessary when using ABS. Also, the infill is different for some parts. only doors need 10 % infill because they have some engravings on them that are hard to print without the support inside, all the other parts only 5%. Post-Printing all I had to do is remove the support none other type of cleaning was necessary.