Cervelo S3 Garmin Mount

prusaprinters

<p>A print for the Cervelo S3 Specific Garmin mount. &nbsp;Printed in ABS with a 30% infill. &nbsp;Uses a small threaded brass insert that should be inserted using a soldering iron for best results. &nbsp;Please use thread locker on the single M3 bolt.</p><p><strong>Safety Warning</strong></p><p>Make sure the T-piece (stem side bracket) is sub flush to the stem bracket using a straight edge and adjust the print or file away material until it is 100% perfect. &nbsp;If your printer is accurate then this print should be ok but please check. &nbsp;If the print is higher than the bracket it could/will crack your carbon bars which would be dangerous!</p><p>Also make sure that the M3 bolt you us is not so long it pushes through the T-piece and into your carbon bars. &nbsp;This will crack your bars which would be dangerous!</p>