Cetus / vertical mgn rail X Carriage e3d Titan extruder v6 and Bullseye

thingiverse

Hey there this is a part of my Cetus MK1 rework. It is a new X carriage from the ground up that fits a E3D Titan extruder with a V6 Hotend and a Bullseye part cooling fan. ( I know first pic is a crappy benchy. That is with zero tuning except e-steps for new board SKR 1.3, hotend, extruder, z axis, and part cooling fan ) You need no supports just print on the ~45deg angle. Depending on the screws you use you may need to only use the 2 on the left side when attaching to the block as the hot end cooling fins will hit the screws. ( this is what I did ) You will need to trim off some of the left Bullseye mount on both the carriage and the cooling duct itself to match the depth of your Titan Extruder. As I am using a knock off and you may not, I find it easier to trim to size and match both rather than have it loose or not line up. The X axis endstop will not trigger before the carriage crashes into the stepper I used a but of wire sheathing to extend it's reach. I'll model something eventually and add it here. Screws: 4 M3 8mm - to linear block 2 M3 12mm - Bullseye to Carriage 4 M4 6mm - Titan to Carriage 2 M3 16mm - 40mm fan to Carriage Links: ( I used knock offs of e3d but here are the originals ) e3d Titan - https://e3d-online.com/titan-extruder e3d v6 - https://e3d-online.com/v6-all-metal-hotend Bullseye - https://www.thingiverse.com/thing:2759439