Chandra's gauntlet (made for medium-sized male hand)

thingiverse

Design: -Based off the Chandra Funko figures and Chandra's style sheet. This is a 33.5cm (13 inch) two-part gauntlet made from six pieces (plus the push-light) Important(!!!): the front part is sized to fit a medium sized male hand. If you have smaller hands than that general standard, this may be too large for you. I'll be posting a different version for smaller hands in a little while. Print Settings Printer Brand: FlashForge Printer: FlashForge Creator Pro Rafts: Yes Supports: Yes Resolution: .15mm Infill: 18% Notes: I used ABS plastic. The warping is a little bit of a pain since you want flat surfaces to join, but nothing a little epoxy putty can't fix :) Post-Printing Print the parts (mine took ~24 hours total for all pieces going at 0.15mm layers) There’s holes alone the axis to attach parts using small metal dowels (Amazon: http://tinyurl.com/hhgnwbj). Or if you're bolder you can just epoxy/hot glue/superglue 'em together too (though that's less stable if you were to drop it). I printed mine in ABS at 18% infill. The walls are ~4mm thick so it makes a nice, hearty armor shell! Glue and/or putty the joints smooth and secure. Join the two parts of the pipes into the bottom, then join both together with the center piece. This was probably the trickiest assembly bit, but turned out fine with some hot glue and patience. I left some mounting holes in the design to screw in some straps. I used polypropylene webbing (1 inch), velcro, and D-rings. Finally my favorite part, just stick on the push light (Amazon: http://tinyurl.com/jpgvof5) onto the front part. You can even change the batteries! Wooo! Enjoy!