Chastity cage - no moving parts

thingiverse

Modular chastity cage with no moving parts: Only the ring flexes a little so it can be put on easily. It's 3 parts, which can be adjusted as needed: Ring, link and shaft. They can be locked through the 2mm holes: As I don't mind locking, I use a piece of filament burned on both sides to permanently hold the shaft with the link, and a piece of filament burned on only one side to lock the ring into the link. Made with Fusion360 Print the ring with the base flat on the printing bed, and both ends slightly curving upward, with supports Print the link with the flat side on the printing bed, and the bit that sticks up on 20º with supports The shaft is trickier: I print it upside down (so the thin part towars the bottom), trying to maximize the layer direction so that it prints full circles where the link is attached, with supports to hold the bit that sticks out.