Cheese Slicer (with tidy wire)

thingiverse

The slicer was totally influenced by bohnded's cheese slicer - http://www.thingiverse.com/thing:9683 (thank you for the inspiration bohnded!) My girlfriend spotted his and asked me to print one but I wanted to make it a little different by enlarging the handle and tidying the wire away if possible. I used 5AMP fuse wire as this is what I had around and knew it could handle the tension. I had to print raftless because of size so it warped a little. Instructions Print the top and bottom Bottom - thread the thin wire into the two holes at the front, then bring it back behind the protruding oblong. Now bring the wire through the semi-circular hole and into the channel at the base of the handle. Bring it up through the first small hole, over the big hole and back through the last small hole Snap on the top piece. Ensure the wire is travelling around the semi-circle and also is being pushed through the big hole in the handle a little (this tightens the wire and keeps it in place) Cut some cheese! ;)