Chiron Stock 5015 part blower, reversed side.

thingiverse

I recommend Polymaker, as supports are easy to remove. Im not too experienced with CAD yet, and this was done in tinkercad. This is a WIP, and I will make a few small revisions after I test this latest version. You SHOULD bend your end stop pin a little bit outward. Try to get it so it sets off, so the block just clears the plate. I will try and design a clip you can mount to the end stop switch, or a ring for the screw itself, and add it to the file. There is 2 positions for the cooler to sit. one sits a bit higher, but hits the block. This is the first revision, which lowers this to HOPEFULLY blow below the block, preventing thermal runaway warnings on marlin As there is only a single point of mounting, you can swing it out of the way, and use the probe still. Make sure you wait until after homing to move it out of the way, and attach the probe, as it WILL collide with the end stop screw. Most of the credit goes to cana3dprint