Chomas Cameo 4 Adapter

thingiverse

This is an adapter for the Chomas Engraving Tip for Silhouette machines. It appears that the original tip was designed for the Cameo 2. The tip works on Cameo 3 machines if a spacer is added, but does not work at all on Cameo 4 machines. This adapter makes the tip fit in the tool holder on Cameo 4 machines. You just have to clip it on to the lowest ring with the open end of the "U" facing upward, then take some masking tape and wrap it around the lower portion of the tip several times to make the lower part wide enough to hold snug within the tool. The adapter makes it so that the clip for the tools can clip onto the engraver tip. This adapter does not make the tool snug in the center of the tool holder. Use masking tape to do that. Also: make sure you use "Sketch" instead of "Cut". If you use "Cut", it can tend to drag just before and after each line, which makes it appear like the tool isn't snug when it is.