Christmas light bow (Weihnachts Lichterbogen)

prusaprinters

<p>A light bow with LEDs and space for a power supply and electronics in its sockets.</p> <p>The flames are actually taken from <a href="https://www.thingiverse.com/thing:3120235">https://www.thingiverse.com/thing:3120235</a></p> <p>The candles are made with 5mm warm white leds.</p> <p>I used a 5V power supply with a 180 Ohm resistor on each LED.</p> <p>The bow, sockets and candles are glued together. The bow cover is just inserted under the bow but not glued. The socket covers are screwed using 3x20mm wood screws.</p> <p>In the left there is a hole to mount a power cable and I placed a 5 volts power supply into the socket. In the right socket there is a esp8266 board with a esphome firmware.</p> <p>This way the light bow can be directly integrated into the homeassistant network.</p> <h3>Print instructions</h3><p>Printed in white PLA, transparent for the flames.</p> <p>0.15mm layer height</p> <p>The bow (bogen.stl) uses supports all over, the candles (kerze.stl) and the sockets (fuss1.stl, fuss2.stl) support on the build plate.</p> <p>The candles should also be printed using a brim.</p>