Chubby cauldron plant pot

prusaprinters

<p>Revisited one of my first designs, made some improvements and settled on the aesthetic of a thicc plant pot, reminiscent of a cauldron.</p><p>Print upside down, rim on the print bed. Brim might be necessary due to small surface area of the rim. Supports are probably not necessary but if your printer can't bridge the gap you can use a single support in the middle that runs perpendicular to the first bridging layer (saves a lot of time and material as opposed to automatically generated supports).</p><ul><li>Perimeters: ≥2</li><li>Infill: ≥15%</li><li>Print time: approx 4 hours</li></ul><p>I also included the F360 file, perhaps a bit messy but the model is fully parametric. You can set the amount of legs, length, angle and more.</p>