Cigarette Holder

thingiverse

Tired of alligator clips squishing your filters? Want something a bit more elegant? Give this a try. The grip on the bottom can be turned to clamp down on a cigarette in the holder itself. This is meant for cigarettes with FILTERS ONLY. Without a filter, you risk melting and inhaling plastic. The standard Base and Screw are meant for slim filters. The Large Screw and Large Base are meant for up to 9.5mm filters. Printed in PLA at 0.2mm layer height with 100% infill. Printed with Cura as different slicers handle the internal dimensions of the parts differently. If you find it isn't working in your slicer, try Cura! Supports are not necessary, but you can get cleaner prints with the pre-supported Base files. Once printed, remove any supports and screw the Movement part onto the Screw. It might be stiff at first. After that, you can insert the screw assembly into the Base and it should snap into place. It should be flush with the Base. The Movement part has two flat sides to fit into the Base and keep it from rotating with the screw. Keep that in mind when you assemble it.