Clamp-on Cable Holder/Organizer

prusaprinters

<p>No need to get sticky or screw up your furniture ;)</p><p>This cable organizer only needs to be clamped on to your desk, your workbench or wherever you want it. The clamp fits on plates with a thickness up to 4cm (about 1.5 inches). If you need it somewhere else, just unscrew it and place it where you need it.</p><p>The individual parts print without supports and the threaded part only needs to be put into the square slots of the holder part.</p><p>I printed it using Prusament PLA (Jet Black), a variable layer height (pretty high but a little lower on the threads and the square slots) and between 20% and 30% infill. Printed in less than 4h. With a few little tweaks in the slicer, it might print even faster.</p><p>I strongly recommend using a brim for the screw and the threaded part (otherwise the square nubs will get messy because they have nearly no surface touching the buildplate). I also added 2mm of brim to the holder part, but it is probably not necessary.</p><p>Note: The one I printed does not yet have these little parts that keep the cable ends from sliding off the holder. But I am sure the adapted version I uploaded still prints exactly as well as the print shown in the pictures.</p><p>The thread in the threaded part and the thread on the screw are taken from the Prusament clamp, so I marked this as a remix. Still, I scaled the inner thread up a little, so you probably won't have any trouble putting the screw in.</p>