Clamp-on Swiveling Airbrush Stand

prusaprinters

<p>&nbsp; &nbsp; &nbsp;I've been needing an airbrush stand that can clamp on to my table in a convenient position and be at the angle I want it at. I looked around online (briefly) and came up with this.</p><p>&nbsp; &nbsp; &nbsp;Fully screw the threaded bit of the holder into the small hole on top of the clamp until the threads disengage. This will allow for full 360* rotation without unscrewing. The holder will have a bit of wobble to it. This was unavoidable with this method of attachment.</p><p>&nbsp; &nbsp; &nbsp;All pieces should load into your slicer in the position that I printed each piece. The positioning of the clamp piece is to minimize supports. I have printed it standing and lying on its side with no noticeable impact on the threads.</p><p>&nbsp; &nbsp; &nbsp;I have included two different screws for the clamp. One is just a screw with a flat top, and the other has a ball and socket joint pad to protect the underside of your table. After inserting the screw into the clamp, just press the socket of the protector onto the ball of the screw.</p><p>&nbsp; &nbsp; &nbsp;This was designed using measurements from an Iwata Eclipse HP CS, but I have also used it with some of my cheaper no-name airbrushes and found the fitment to still be secure.</p>