Classic Sixties Tardis interior Playset

thingiverse

A play set model of the classic sixties Tardis scaled for the 5.5" action figures and designed to be printable on a 200x200mm bed. Modelled on how it appeared in 'An Unearthly Child'. This is a large model with lots of parts at a rough estimate it's going to take around 240 hours to print (excluding the console) and use up about 1.5kg of filament. I used white filament throughout, although with hindsight, I should have used a light grey, or silver filament for the Scanner Monitor assembly. 25/02/19 (A) I've added optional hexagonal floor panel parts in case you want to print a floor. The panels have gullies underneath for running any wiring. I printed them upside down, but if your bed uses tape, you may want to print them the right way up with supports. Print out as many hexagonal floor panels as you require. Alternatively use a piece of hardboard. 25/02/19 (B) I've added some optional corner brackets which clip over the tops of the walls to give the shape a bit more rigidity. 20/02/20 (A) Optional. Uploaded Roundel 3 Column 1 and Roundel 3 Column 2 files. Printing each of these twice will produce two optional extension walls to extend the interior door wall and the opposite roundel wall, so that the playset is closer to the shape of the BBC stage. This replaces the 2 roundel column wall that was here previously. This is the minimum length required to use the addon pack. 20/02/20 (B) Optional. Moved from the Tardis Playset Addon Pack A set of full hole roundel walls which can either be glued over an existing wall to give the roundels more depth, or be backed with something translucent for back lighting and added deep corner brackets (there is only one 90 degree deep bracket, you'll have to mirror it for the second one). The double width main door uses a different hinge technique (using unprinted filament hinge pins) you'll have to carefully remove the single wall hinges