Clepsydre - Water Hourglass

prusaprinters

<p><strong>#RespectSciences</strong></p><p><strong>#WaterConcept</strong></p><p>&nbsp;</p><p><strong>You will need to add water into the clepsydre before the end of the print.</strong></p><ul><li><strong>First Print an Infill Cup</strong> - You will need it to have the exact amount of water (if you add too much water, the clepsydre will not work)</li><li><strong>Then print the Clepsydre</strong></li><li>Add a <strong>pause</strong> in your slicer at z=114mm (before it starts closing the top)</li><li><strong>Fill the clepsydre with water</strong> - Use your Infill Cup (water up to the top line)</li><li>Finish the print</li></ul><p><strong>To start the clepsydre :</strong></p><ul><li>Return the clepsydre (water in the top)</li><li><strong>Shake the clepsydre</strong> once</li></ul><p>&nbsp;</p><p><strong>Print Settings :</strong></p><ul><li>Printed on MK3S</li><li>Filament tested : PLA</li><li>Nozzle 0.4mm : 0.20mm tested</li></ul><p>&nbsp;</p><ul><li><strong>Brim : 5mm</strong></li><li><strong>Perimeters : 4</strong></li><li>Solid Layers : Top 6 - Bottom 5</li><li>Infill : Concentric 20%</li></ul>