Clip-on cable guide for Anycubic i3 Mega side frame

thingiverse

This is the side frame version of my clip-on cable guide for the Anycubic i3 Mega. I didn't print these yet, because I don't necessarily need them, but they should fit without problems as they are equal to the top version, but with the shorter "arm" a bit shorter to fit the side frame. I needed some sort of cable guide to guide my hotend cable. I fitted some fabric hose to my hotend cable to reduce its stiffness which it had with that original plastic hose. There are two versions of this clip, one with the guide pointing upwards and one where it's pointing downwards obviously. They both work equally good, it is just a matter of aesthetics which one you want to fit. The guide clips tight on the side frame as I did not want to drill holes or use the existent screws. ATTENTION: These guides only fit at the side of the printer frame, for the ones fitting to the top frame please visit my other makes. UPDATE 05/28/2018: Finally managed to print one of these things, so I added a picture. (Sorry for bad quality!)