Clips for TV table with 16mm legs - print in NYLON

thingiverse

These are clips for the smaller tables with folding legs (TV dining tables etc.). They are meant to be attached with rivets. You could use other hardware but then your tabletop wont be flush. Most of these tables have a cheap vinyl upholstery on the top that can be easily lifted up after removing half of the staples (unless you are just replacing it then remove all of them). Sometimes there is some kind of metal or plastic edge holding the stapled material down but if you can get it off without breaking it you can reuse it to make a new piece of upholstery look factory installed. Recommend printing in Nylon as the nature of a clip is to flex a lot and even ABS will probably break on you. Which if you are upholstering over your rivets would be very frustrating. I can tell you from experience. I used Taulman 910 because its the only Nylon I had, worked great. Still holding up.