Cameo 4 - Multi Pen Holder

thingiverse

This is a Multi-Penholder for the Cameo 4 because I don't like the original pen holder at all. I have the impression that the pen tip sits too close to the paper and that it is pushed down even further by screwing it in. In addition, the pins are not held well, they can still move sideways in the original holder. That's why this (admittedly more complex) construction with the most suitable insets and lateral fixation - it's worth the effort! Without an inset you can use pins with a diameter of 13 mm. A corresponding inset is recommended for thinner pencils. <b>Since the parts are very filigree and with low tolerances, resin printing is recommended! The parts are not optimized for FDM printing (but it should also be possible if your printer is set up well). For FDM printers, the note at the bottom may help...</b> <b>The shaft should have a diameter between 15.3mm and 15.4mm. Below that it can start to wobble (especially with the <a href="https://www.thingiverse.com/thing:5274960">Engraver Inset</a>) and above that it gets tight in the tool holder.</b> The Jig to adjust the distance of the pen tip is identical to that for my <A HREF="https://www.thingiverse.com/thing:5232336">Heat Active Pen Holder for Camero 4</A>. If you are already using this, you do not need to print it again. If you need a special inset: I've attached it as a STEP file. (You can also ask me - if I can spare some of my limited time, I will try to help you). <b>YOU can please also help:</b> - to expand the list of pens, I can only list the pens that I use myself. - If you have customized the inset for your pen, please share it with the others as a remix. <b><i>That will help everyone!</i></b> <b>What else you need:</b> * Hex-Nut M3 (DIN 934) * Self-Locking Nut M3 (DIN 985) (if you don't have one, a second "normal" one is enough (like for the holder) and if it should come loose during use: maybe a tiny little drop of superglue) * M3 x screw 18 mm or longer (I used: M3x18 mm (DIN 912)) * Aluminum sheet 14x10x0.5 mm (ONLY if you want the automatic tool recognition (from the blue adapter, or get a 0.5 mm sheet and cut it to size)) <b>Please note that these are not original Silhouette accessories, so using them can invalidate the guarantee. Use is at your own risk.</b> --- Examples of the insets: * SAKURA "Jelly Roll" = <b>9.5 mm</b> * SAKURA "Quickie Glue" = <b>9.5 mm</b> * STABILO "pont 88 Fine Liners"= <b>STA</b> * STAEDTLER "Lumocolor" = <b>9.5 mm</b> * <b><a href="https://www.thingiverse.com/thing:5274960">Engraver Inset</a></b> = <b><a href="https://www.thingiverse.com/thing:5274960">ENG </a></b>