Co2 Gas Sensor Mount / Container Mg 811 CO2

thingiverse

This is a Mg 811 CO2 Sensor protection container and mounting unit that I created as part my Third Year Engineering Project. It is specifically design to fit the above named sensor however, i understand that most of these inexpensive sensor are similarly shaped (so it might also fit others with perhaps some re-scaling). There is a 90 degree slot for inserting the protruding cable as to avoid the cable or sensor from being damaged due to pulling. The mount has good tolerance to fit sensor to isolate it from water, dust, damage etc. The lid/ cap is a complex shape and is made to fit but may need some clean up after printing due to small fillets etc. I would suggest printing at 100% infill for ideal protection. This can be printed without any supports. Thanks for viewing.