CO2 Powered Nerf Magstrike mod parts.

thingiverse

These are a few ideas to modify your Nerf Magstrike to make it REALLY COOL!\nThis includes some of the parts needed to mod your Nerf Magstrike into CO2 powered - 16-gram CO2 cartridge holder attached to the side of the Magstrike. The button on the back of the bladder to ensure the micro-switch gets hit accurately A 40mm piston chamber expander for more power per shot. Check out https://www.youtube.com/watch?v=i4KYusSSZDk for the complete instructions! If you have any questions, feel free to comment below. I'll do my best to answer them. UPDATE: Added a 2x CO2 holder to the Tactical Rail! Also added a front button to finish off where the pump handle used to be! See the instructions! Instructions For printing the chamber expander or the button - Orient these parts upside-down, with the hollow side up. The chamber expander needs full infill on slow speed for strong layer bond - it will withstand over 50 PSI of pressure. I used pressure pipe PVC glue and a cable tie to secure the expander in place. Keep the cable tie there for extra support! Print the CO2 cartridge holder as instructed. To install the second CO2 holder on the Tactical Rail: Number 1 - is a straightforward push-in fit. A little doubled-over paper may be needed to ensure a tighter fit. Use the paper wrap or something similar to tighten the thread.