Coffee Drip Tray Spacer

thingiverse

I have a Keurig for tall cups but the space between nozzle and the cup was so far that I would get splashing on my counter. I created this to raise the cup up to the height of the nozzle. This is exposed to heat so make sure you use a filament designed for high heat. As long as your coffee make has a hole in the center of the drip tray this should work fine for any brand. This is my first original design. I had trouble getting the pin to print but after I adjusted the infill pattern and density it printed fine. The measurements are Disk Height 15mm Disk Diameter 100mm Total Height with pin 20mm Diameter of pin 20mm Diameter of pin recess 21mm I am in the process of designing a tray for them to nest in because they keep sliding around the counter when not in use.