Coiled Snake Ring

thingiverse

A coiled snake ring that I modeled in zbrush. This is, honestly, just a test so I could make sure the scale was right before I sent it off to shapeways for a metal print. I've put it up on shapeways, for anyone who is interested -http://www.shapeways.com/model/696871/snake-ring.html Instructions I had to print it, standing up, and with full raft support. I haven't tried printing it on its side, but I figured that it would require a huge amount of sanding to look nice that way, with the raft covering a whole side, instead of the bottom and interior. Again - I don't honestly think the results are quite nice enough to wear it, legitimately, but it was a good way to test to make sure it was the right size before I put it on shapeways.