Colido (Print Rite) 2.0+ Nozzle fan

thingiverse

I have the Colido 2.0+ 3D printer and had some issues where the plastic would warp because it didn't cool quickly enough, so I made this snap-on cooling fan inspired by https://www.thingiverse.com/thing:1710023. The difference in print quality is tremendous. You will need at least two (or four) M4 screws 20mm height to sandwich the top part, fan and bottom part and then you snap the part on. I have moved the fan a little to the left, so it doesn't touch the front end of the printer. For the wiring, I have wired the fan directly to the board where it says Fan (see image) with approximately 1 meter cable. Conveniently, it has reserved a place for cooling the nozzle which is handled by software :D In order to access the board, you have to turn the printer on its side and unscrew the plastic bottom part (be sure to shut it off first) and plug the JST connector on the board. Beware the polarity, or else it will not work. I have include the fusion360 files too, any comments or suggestions are welcome :)