Commodore 1084S-P folding stand foot

thingiverse

As the title says, this is a design for a stand foot replacement for the Commodore 1084S-P monitor. Tolerances on the lugs are tight, so if your printer is not fully calibrated it may need a bit of trimming the lugs. I didn't copy the original design because it is a bit thin for a printing leg to be strong enough. Also I have trimmed the feet where it touches the table to 12 degree angle so the monitor will not stand on an acme as the original. Because the foot is 252mm long it needs a printed with a quite big bed, or you can try to place it diagonal on the bed surface to see if it fits. As always, I suggest printing it with abs or asa, because heat of the monitor could soften the lugs on pla and chronic tension can deform petg. It needs supports when printing on the lugs, but other than that its an easy print. Enjoy :)