Comp XL Micro Quad Frame

thingiverse

This is the larger cousin to our popular Comp108 micro quad frame. The Comp 108 design can be found here: https://www.thingiverse.com/thing:2264856 The Comp XL measure 121mm diagonally and is an easy to print micro quadcopter frame which has been enlarged from the original version to allow 3" props. We have produced three different versions: The Basher – This version of our original design has extended arms, but is in all other ways identical to its smaller cousin, maintaining the motor mount spacing for 11XX size motors. The Cruiser – This version has thinner arms than the larger "Basher" version, which will of course result in reduced durability. It also retains the same motor mount spacing for 11XX size motors. The Basher HD – So, 11XX motors are too small for you? That's okay, we made a version that will allow you to mount up your 13XX - 14XX size motors! Notes: - The Comp XL frames can use flight controllers with either 30.5mm or 20mm hole spacing, 4-in-1 ESCs of both sizes or smaller individual ESCs, and 1103-1407 size motors (use 6mm bolts for motor mounting on all versions). - We have designed a range of camera mounts, if you don't seem something that meets your needs feel free to be creative! Remember that the outside holes will line up with a full size flight controller mounting pattern, so you can use one of the many already available camera mounts, or use one of the flight controller stack plates as the base of your own design. - The models should be printed logo side down for best results, and it is recommended that you take the time to orient your infill to align with the arms to increase overall strength. - Experiment with materials, settings, and remember to have fun! Top plates and camera mount designs can be found here: https://www.thingiverse.com/HalfAshby/designs Also, check out Max's design for a camera mounting solution here: https://www.thingiverse.com/thing:2561423