Constant-velocity joint_Rzeppa

thingiverse

Hi I made a copy of the standard speed joint with the openscad program, the hub drilling tool requires a 2MM drill and a 5mm smaller hole first, then the bigger ones, remember the guide pin, just drill your finger. fit the M5 nuts into their slots, pull them into place on the thread and with the help of the other nut, assemble the joint inside the outer shell hub center piece and balls diameter 4.8-5mm, put the axles in place tighten then done. I will make a cover as long as I get a ninjflex order. I can do this with a different attachment later if needed. with this you can really transfer the power forward in the corner.