CoralVue Klir Di-4 Filter Adapter for Red Sea Sumps

prusaprinters

<p>The CoralVue Klir Di-4 roller filter will not fit in the Red Sea sump out of the box. This adapter will allow the Klir to slide right in place of the stock filter sock and create a dam that will allow the water level in the drainage section to raise to the 1.5-in needed to trigger the roller sensor. Please remove the filter sock and drawer before installing the Klir filter.</p><p>I have tested this on my Red Sea MAX E-170 add-on sump that has a drain area width of 117mm. It may also work with other single sock Red Sea sumps, but I have not tested it personally. Please measure your drain area before printing.</p><p>I recommend printing this with 100% infill since it will be submersed in the water. Also, please use a water safe filament that will not degrade or leach into the water over time.</p><p>Installation: <a href="https://youtu.be/YKAKFAieYZA">https://youtu.be/YKAKFAieYZA</a></p><p>Installed and running: <a href="https://youtu.be/BuX2pS853yE">https://youtu.be/BuX2pS853yE</a></p><p><strong>Updates:</strong></p><ul><li>10/1/18: The new potbelly version makes room for the optical sensor and motor to face the front of the sump. It also reduces the amount of material needed to print the adapter by hollowing out certain parts without sacrificing strength or seal.</li><li>9/29/18: Uploaded v4.1 with a small inset lip that the Klir collar rests on. This seems to seal even better.</li></ul><h3>&nbsp;</h3><h3>Print Settings</h3><ul><li><strong>Supports: </strong>No</li><li><strong>Resolution: </strong>0.2</li><li><strong>Infill: </strong>100</li></ul>