Cord Minder for DC Power Supply

thingiverse

DC Power Supply Cord Minder Problem: I may have too many of these DC Power Supplies. But also they come in handy for electronics projects all the time so I tend to keep them. They can be hard to find in the drawer and get all tangled together. Also many times the cord is way too long when I go to plug them in. Design: I designed and printed these little cord organizers to help with those issues. It plugs into the Power Supply when not in use, and dangles below to manage the cord when plugged in. There are three versions depending on your needs. The round one is for very small ones. The oval is for most normal ones, and the sideways oval is for ones that have plugs rotated at 90 degrees from a normal one. Use: Plug your Power Supply into the socket-like holes and then wrap the cord around it. Then slide the end of the cord into one of the slots for storage. If the cord is too thick, the tab can be bent slightly. When it is time to use the Power Supply, unwrap as much cord as needed using the slots to hold the correct amount of slack. Printing: Needs supports. Low infill, I used 10% with normal PLA and it worked fine.