Corn Hole Wall Bracket

prusaprinters

<p>I designed these to hang my cornhole board in my garage. They are probably over engineered but my boards are heavy (3/4 in plywood deck and 2x4 sides) and I didn't want to risk them falling off the wall. When hanging them make sure to use washers and mount the hangers into studs.</p> <p>Printing:</p> <p>I printed these with a 0.6mm nozzle with 3 perimeters, 4 top and bottom layers and 25% Gyroid infill and 0.30mm layer height. This is probably overkill but my cornhole boards are heavy and I didn't want them falling off of the wall.</p> <p>If you are printing with a 0.4mm nozzle then I recommend increasing the perimeters to 4-5 and top and bottom to 5.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>I3 MK3S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.3</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>25%</p></div> <p><strong>Filament:</strong> Prusament PETG Carmine Red</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>Note: Printed with a 0.6mm nozzle. If printing with a 0.4mm nozzle increase the perimeters and top/bottom layers by 1 or 2 (depending on the weight of your cornhole boards).</p></div> </p></p></p> Category: Other