Corsair Headphone Stand Curved Crown

thingiverse

This is a curved crown for the Corsair ST100 headphone stand. I didn't like how the sharp corners of the stand would press into the head cushion. The crown just slides into place, no adhesive required. I printed at 50% infill. Less infill would probably be fine, I just wanted to make sure the retention clips were sturdy enough. To install start the rear of the crown on the front of the stand on a slight downward angle and slide it to the back of the stand, keeping downward pressure. The notch in the retention clips goes towards the back of the stand. 6/6/20 - Added a file that is wider and has a lip on the front. That way the headphones can better free hang without being pressed up against the stand and won't slip off. Print with supports