Corsair iCUE 4000X & 4000D AIRFLOW style Front Panel Custome

thingiverse

Custom Elite Dangerous version of my Corsair iCUE 4000X Front Panel design showing the 3 base Elite badges, Combat, Exploration and Trading (from top to bottom) This will fit the Corsair iCUE 4000X & 4000D cases as they are the same chassis. If you have a 5000X/5000D it will not fit but could possibly be scaled up to fit, depends on the peg spacing. There are 2 versions included and will fit on an Ender 3 bed, including a brim, if your Slicing software is set to use the full printable size of the Ender 3's bed (235x235mm), not just 220x220 which typically is set as the default. V1: A top and bottom piece that require attaching together with the Connector pieces. This version uses printed ball pegs that push into the case. These are OK, but be careful when fitting the panel onto the case, as they are undoubtably the weak point of the design, especially if printed in PLA. V2: Exactly the same as V1 but with the plastic pegs removed and holes added to allow the use of M3 x 4mm x 5mm brass threaded inserts and 5mm ball head screws. NOTES: 1: The ball head screws have a head size of 5mm and are M3 threaded, the most common source of these seems to be RC car part suppliers, specifically Tamiya part # 19804205 will be the correct size for an M3 brass threaded insert. 2: I'd suggest a minimum of 60% infil to stop fan light bleeding through the solid parts, best printed in a dark/opaque filament 3: Again, make sure your Slicing software is set to use the full printable size of the Ender 3's bed (235x235mm), not just 220x220 which typically is set as the default. Print Settings: Quality: 0.2 Infill: 60% (I went this high for rigidity and strength) Brim: Yes (Personal Preference) Supports: No Material: PLA