Couch Table Raiser Karin 160x70 (BordBirger, Mio)

thingiverse

I needed to raise my new couch table a bit so i designed me a raiser that is just a substitute for the default plug that was included in the table. You can chose to raise it between Height: 15 mm (This is the one i used and now it matches my old couch table height) 20 mm 25 mm 30 mm 50 mm Print Settings Printer Brand: RepRap Printer: Wanhao i3 Rafts: No Supports: No Resolution: Medium Infill: 20% Notes: ABS Prints Layer Primary Layer Height: 0,2000mm Top Solid Layer: 6 Bottom Solid Layer: 6 Outline/Perimeter Shell: 3 Outline Direction: Inside-Out Addition Use Skirt/Brim: Yes Skirt Layer: 1 SKirt offse from part: 0 Skirt Outlines: 16 Temperature Primary Extruder: 247 Celsius Layer 1 Hotbead: 100 Celsius Layer 1 Layout on print bed Put the table raiser (===) on the center of the print bed like below _ _ _ _ | | | | | ==== | | | | | WIth these settings it took about 2 hours to print each raiser, so in total about 8 hours.