Cover for Male XT60 connector

myminifactory

I struggled to find a cover for a male XT60 connector (or XT60E, in my case). So I designed this one. It is easy to install and remove. Prevent dangerous short circuits when a male XT60 connector is not in use but still connected power. NOTE: I am using it on my Creality Ender 2 PSU, with an output voltage of 12 V. Use it at your own risk, your filament's dielectric properties may be different. Prints without supports. I was too lazy to measure the connectors myself (besides, they were already installed when I decided to make the cover), so I used this model by Simon Hersche as reference