CP33 Suppressor Shroud V2

thingiverse

CP33 Suppressor Shroud V2.0 Major improvments: - include rail guids to work with Digitalnimbuslabs invader PDW brace rails. - relocating pic rail hole to align with a space in the rail. - multiple models for different needs. - more appealing design. - and future design integration https://shop.digitalnimbuslabs.com/invader-pdw-hardware-kit/ Print on a 45 degree angle on the muzzle end of the shroud. (shown in image) Add brim to ensure the print stays stuck to the bed. There should not be a need to print with supports on, but if oyu want you can. If print is under extruding, try printing at a slower speed. Shroud replaces stock mlok barrel shroud on the CP33. Use stock screws to mount the shroud. Shroud Models: - CP33 Shroud mlok - Approx. allowable width of mlok attachments = 13.4 mm this is the width of the Farrow tech CP33 Angled foregrip. - CP33 Shroud mlok ext. - Shroud with mlok slot extended as to allow for wider attachments. (this model has not been printed and tested) - CP33 Shroud mlok no rail - This model does not include the area for the igitalnimbuslabs brace rails. If you dont need that attachment then this is the model for you.(this model has not been printed and tested) - Cable holder - cable managment guide. printed seperatly and glued onto shroud, as needed. designed for streamlight cable diameter. Light compatibility designed for Streamlight TLR RM 2. Pressure pad half installed with shroud and other half using supplied pic rail mount from Streamlight. Suppressor/muzzle device compatibility Designed for the OSS Rad 22 Should be compatible with suppressors that have a diameter equal to or less than 1.08 inches, and a length greater than or equal to 5.57 inches. Harware needed: 1 - M4 x 35mm bolt (Found at lowes or homedepot in packs) 1 - M4 Nut (Found at lowes or homedepot in packs) Orginal harware for the stock mlok barrel shroud, it should be 2 screws Any other hardware to mount an mlok attachment