cr-10 control box base plate & legs for dual 120mm fans

thingiverse

a fan base for the cr-10 control box. this piece replaces the original base plate. it screws into the control box with the original screws, the legs attach when screwing in the fans. the legs are suprisingly solid when filled completely and the holes allow the original feet to be screwed in. I use two fans in a push-pull configuration. I had two different fans lying around and put the stronger one in the front pushing in, (tested by putting a flimsy trash bag over the base with fans running). ghetto airflow analysis with some incense shows some exhaust air looping around to the input, the vanes help but haven't completely resolved that issue the listed remix items were used for inspiration and measurements, but the actual model is designed completely from scratch in tinkercad. ####**changelog** ##### 0.2.1 (untested) further Side wall reinforcements * made side walls 1.6mm (2 inner and outer shells, no infill) * added wedges to the side walls for stabillity while printing ##### 0.2.0 (untested) replaced honeycomb grill * reduced honeycomb supports to 2mm ##### 0.1.2 (untested) remade the front/back face * increased side walls to 1mm for stabillity (and removed sloping) * added 45° angled bottoms to overhangs similar to curas 'make overhangs printable' * increased middle screw cutout to 10mm wide (my dingus didnt fit) ##### 0.1.0 original release