Cr-10 Direct Drive Modified for wire management and filament sensor

thingiverse

Fixed the stl file. made room for the filament feeder switch to be pressed and enhanced the thickness of the supporting bar. OK I deleted the older files and I modified the direct drive after I printed it and ran into trouble and had to cut the wrap around square to be able to feed the filament. DO NOT PRINT I just realized the Wrap around Square will block the filament press lever from pressing down!!! You will have to cut the square. in the bak to make room for the lever to be pushed down. Just finished removing all the quirks out of this file and never tested if it fits well with the filament sensor. this is a second iteration to make it stronger and provides a way to keep the wires vertical and well protected. A 1/16 drill tap and an m2 8 mm screw may be useful to better secure the filament sensor. Modified the first file into the third to make room for the filament pedal to have room when adding filament.