CR-10 legs

thingiverse

These legs lift my CR-10 printer by 90 mm just the right amount so you can get your hand and arm under the bed to adjust the bed height without touching the bed. I didn't want to place the control box under the printer just wanted to get to the bed adjustment screws without bumping the bed. The legs are held firm with a wire tie, I also glued small rubber feet only about 1 mm thick to the corners to prevent any movement on my desk top. ( I used an old inner tube) I can now do the bed leveling with no problems. You can also store tools etc under the printer. Printed with 10% infill turned out very strong.