CR-10 Micro Swiss Cooler

thingiverse

This is a modular cooler for the CR-10 with a Micro Swiss hot end. Both fan mounts are installed with no screws making it easy to remove them for working on the hot end. To install the hot end cooler tilt it forward and slide the bottom over the hot end screws then straighten it up and slide it down. The bottom of the fan mount should be even with the bottom of the hot end cooler when it's fully installed. The part cooler installs easily, just set it in the cradle on the part cooler and snap the ducts back in the pockets. CAUTION!... I tried to cut weight any where I could. The part cooler is only 1mm thick in most places, be careful when flexing the ducts during installation/removal. Edit: 10/5/2018 Updated the part cooler tips to angle them down a bit more and provide a wider cooling area.