CR-10 Mod - X axis Tensioner

cults3d

Update of 02/06/2019 MAJOR UPDATE X Tensioner for CR-10 / CR-10S Mk7 Version Upgraded the guide system and simplified all the models Unified the screws dimensions (with my other tensioner versions) Modified the minimum belt tensioning position (for short belts) Slightly increased the tolerances compared to previous models Added a New Shaped Knob, more "fancy" than the previous version. Printing Tips : Body --> Print in Vertical (better with supports, but not strictly necessary) Screw --> Print Horizontally, lying on the flat face Knob --> Print in Vertical (No supports Required) Hardware Requirement : For the OEM Version : 1 Screw M8x25 2 Bearings F688Z 1 Screw M4x8 (Button Head) 1 T-Nut M4 NOTE : The OEM screw version has been prepared due to some users request, but I did not recommend to use it due to possible weakness problems.! For the GT2 Version : 1 GT2 Pulley 20T 1 Screw M3/M4/M5 x20 (according the Pulley bearings) 1 Screw M4x12 (Button Head) 1 T-Nut M4 Fixing system : 1 screw M4x8 1 t-nut M4 The models are designed for the material stated below. Note : All the pieces has been tested and fit correctly. If you cannot fit the pieces after the print, you are doing something wrong! (Sorry guys, but I am tired of comments from people who are unable to print, and blame the models...) Enjoy The tensioner has been designed for the CR-10 (and relative versions), but can be used also for the Ender 3, and similars printers that uses 2020 V-slots profiles. Enjoy . . . . . . Credits : fooyabt - fessyFOO's Yet Another Belt Tensioner by Fessyfoo are licensed under the Creative Commons - Attribution - Non-Commercial - Share Alike