CR-10 V3 Hero Me Adapter (gen5/6) for Use with Stock Titan Extruder Mounting

thingiverse

This remix is a "drop-in" replacement for the stock Bowden/titan setup on the CR-10 V3. Most remixes require you to cut a new Bowden tube and/or move your Titan extruder up due to clearance issues with the 40mm hot-end fan. I'm too cheap to do that. Instead, this remix just shifts down the 40mm fan using a small adapter piece. You will lose a minor amount of efficiency on the hot-end fan, but I haven't noticed any difference in maintaining an accurate hot-end temperature. The gantry adapter is necessary to align the holes of the titan mounting plate as they are about 8mm left of the included Hero Me Gen 5/6 adapter piece. Overall, just install everything as normal, but use this adapter for your stock 40mm hot-end fan and gantry adapter. You will need the standard hardware for the Hero Me Gen 5/6 base, collar, and fan duct. In addition, you will need: 3 x M3 nuts (inset in the gantry adapter) 7 x M3 x 8 screws (4 are used to screw in the adapter piece to the Hero Me base, 3 to screw into the gantry adapter from the back of the stock V-3 gantry plate) As a FYI, the bowden tube length is ~81.5mm for the stock V3 orientation. If you want to move up the titan extruder, you will need a new bowden tube, elsewise the pressure will cause the bowden tube to rise out of the hot end.