CR-10s Digital depth gauge holder for bed levelling

thingiverse

I buyed a digital depth gauge for levelling the bed of my CR-10S, but printable holders found on line do not fit my gauge This is 2 part print that must be glue together (see picture for final assembly) Print with your everyday settings, glue with CA et voila. One note... this type of digital gauge, as opposed to the dial type, require a use of a rubber band for pull down the needle. Alternatively, you can remove the spring that stiffen the needle (it require you remove the 4 screws under the sticker on the rear, remove the cover, then take apart the needle. the spring is a flat metallic sheet underneath the needle plastic).