Craftbot+ ELP webcam mount

thingiverse

Created this mount to fit the ELP-USB100W07M-MHV100 (100 degree FOV) , but will likely fit any of the ELP webcams that have the an inner mounting holes at 22mm. After increasing the resolution in Octopi to full 720p, it looks like it's a little too wide, so I've lowered the resolution to fit most of the just the inside of the print. Time lapses look fantastic, and camera rests just slightly above above home Z level. The Shroud was added after as the LED lights cast a slight haze onto the image, and might be seen from the sensor. It helps make the image clearer in general. The cable is ran up behind the camera in a tiny gap that exists in the corner, follows the LCD cable and down into the back of the printer where you can plug it into a Pi, or extend out to wherever you need it too. Have fun Print Settings Printer: Craftbot+ Rafts: Doesn't Matter Supports: Yes Resolution: .1 Infill: 30 Notes: I printed so the curved part is on top, with support for the back side of the angled mounting piece.