Crashex v2 FPV drone

thingiverse

The Crashex v2 is a FPV racer with a motor-to-motor distance of 21,5 cm. The camera angle is fixed, but I am planning to design a wedge that can be inserted if a bigger/smaller angle is desired. This is a proven design that flies nice and stable with a CC3D flight controller, M2204-2300kV motors from Ldpower and 6030 props. The arms are designed to protect the motor cables and there is plenty of room for all components. With a 2200 mAh battery I achieve flight times between 10 and 13 Minutes. V3 will probably be done within the next 6 months. The plan is to achieve an even lower weight without losing its robustness and to fly it with 3-blade props and shorter arms. The distance between the upper floor and the second floor is a little too short in v2, so that some cables keep the battery from lying flat on the upper floor. That has been no problem so far, but is not very nice and will be addressed in v3. Print Settings Printer Brand: Prusa Printer: Prusa Steel Rafts: No Supports: No Resolution: 0.2 mm Infill: 50 % Notes: The pieces are designed to be printed without supports.